Wiring & Connectors
T-One Connector Repl. 119146 - 119147 - 220-119147F1
Draws power directly from the vehicle battery and uses less than 5 mA of the vehicle circuit for sensing to turn the trailer functions on and off Will work with either LED/Incandescent bulbs (vehicle & trailer)The taillight circuit has been upgraded to work with vehicles that use a pulse width modulation (PWM), this will allow the convertor to turn on fully and gives the trailer lights full brightness during activationThe trailer brakes will override the hazard lamps when the brake is activatedThe unit is rated for up to 2.1 amps for Turns/Stops circuits and 7.5 amps for the Taillight circuitWill work with most vehicles that have a multiplex system for lightingCan be used on a 2-wire or 3-wire systemIncludes integrated protective cover
T-One T-Connector Harness 4 Way Flat - 118847 - 220-118847F1
Taylor #2 Brass Grommets And Washers (12 Sets) - 1231 - 32-1231F1
Perfect for boat covers, tarps, tents and fabric. Quickly installs #2 size grommets with 3/8" hole. Set contains 18 #2 brass grommets and washers. "Vision Packed" on display card.
Taylor 11992 Super Support Pole W/Canvas Snap, Grommet Tip & Plain End Cap, 36"-64" - 11992 - 32-11992F1
This fully adjustable aluminum support pole is 3 support poles in one. Includes a male canvas snap, grommet tip, and plain end cap with the pole. If you have a female canvas snap or a grommet on your boat cover, you can get a support that will work with your cover. A durable plastic adjuster sets the correct height for your cover.
Taylor E-Z Grommet Set Includes Hole Punch, Setting Tool And 18 #2 Brass Grommets And Wahers - 1365 - 32-1365F1
Perfect for boat covers, tarps, tents and fabric. Quickly installs #2 size grommets with 3/8" hole. Set contains hole punch, setting tool and 18 #2 brass grommets and washers. "Vision Packed" on display card.
Taylor Hidden Hold-Down Fasteners With Nuts And Rubber Grommets (4 Per Pack) - 1607 - 32-1607F1
Come complete with nuts and rubber grommets.
Taylor Recessed Wired Light Extension Pack - 46307 - 32-46307F1
Quickly add more lights to your recessed wired light set. This pack of three additional lights easily connects to your existing lights. You can add up to two extension packs, running a total of nine lights off one solar panel.
Technology Research 90° Angle Adapter, 15A-30A - 95245508 - 802-095245508F1
Adapts 15A to 30A.
Technology Research Hardwire Surge Guard, 50A - 35550 - 802-35550F1
Permanently installed Surge Guard protects your RV bumper to bumper from faulty park power. Protects from the weather and theft and eliminates handling. UL Listed. Automatically shuts off the power when excessive voltage, Low (Less than 102V) and High (Greater than 132V), or open neutral is present. Automatic reset on power restoration. Caution indicator light indicates miswired pedestal, reverse polarity and elevated ground voltage. 128 second reset delay protects A/C compressor. Fits neatly inside RV's electrical compartment. Weather resistant. Joules of surge protection. Easy installation. UL Listed. Optional Remote Power Monitor LCD Display, sold separately. Plugs into remote port on Surge Guard models 34520 and 34560. Conveniently and remotely monitors RV electrical power. Detailed fault screens show 16 information fault screens, incoming line voltages and current being used. Joystick offers easy screen navigation. Stores faults (if any). Plug and Play. Connects to a RJ12 (6 pin) connector cable (included).Not compatible with previous models that do not have a telecon jack.
Technology Research Straight Adapter, 15A-30A - 95215508 - 802-095215508F1
Adapts a 15 Amp male plug to a 30 Amp female.
Technology Research Straight Reverse Adapter, 30A-15A - 95225508 - 802-095225508F1
Adapts 30A male to 15A female.
Terminal Block - 2404-Bss - 661-2404F1
A closed back design completely insulates power from the mounting surface. Each screw pair is one isolated circuit. Optional jumpers allow creation of common circuits.
Terminal Block 8-Gang - Fs40690 - 11-Fs40690F1
Combines negative and positive buses in one block.
Terminal Block Bus Bar 4 Gang - 46206-04-Bx - 12-4620604Bxf1
Terminal Block Ind 10 Cir 20A - 2410-Bss - 661-2410F1
A closed back design completely insulates power from the mounting surface. Each screw pair is one isolated circuit. Optional jumpers allow creation of common circuits.
Terminal Block Ind 10 Cir 30 - 2510-Bss - 661-2510F1
A closed back design completely insulates power from the mounting surface. Each screw pair is one isolated circuit. Optional jumpers allow creation of common circuits.
Terminal Block Ind 12 Cir 30A - 2512-Bss - 661-2512F1
A closed back design completely insulates power from the mounting surface. Each screw pair is one isolated circuit. Optional jumpers allow creation of common circuits.
Terminal Block Ind 2 Cir 30 A - 2502-Bss - 661-2502F1
A closed back design completely insulates power from the mounting surface. Each screw pair is one isolated circuit. Optional jumpers allow creation of common circuits.
Terminal Block Ind 4 Cir 30A - 2504-Bss - 661-2504F1
A closed back design completely insulates power from the mounting surface. Each screw pair is one isolated circuit. Optional jumpers allow creation of common circuits.
Terminal Block Ind 6 Cir 20 A - 2406-Bss - 661-2406F1
A closed back design completely insulates power from the mounting surface. Each screw pair is one isolated circuit. Optional jumpers allow creation of common circuits.
Terminal Block Ind 6 Cir 30 A - 2506-Bss - 661-2506F1
A closed back design completely insulates power from the mounting surface. Each screw pair is one isolated circuit. Optional jumpers allow creation of common circuits.
